6-10.Using single split mode; 6. USING THE OPERATION PANEL- Page 32

6. USING THE OPERATION PANEL

BAS-341F,342F

25

6-10.Using single split mode

By using single split mode, it is possible to change up to 100 patterns immediately.

1. Move DIP switch 

B

 No. 1 to the ON position. This will activate single split mode.

(Refer to "10.DIP SWITCH".)

2. Turn on the power read in the patterns which have been programmed for split sewing.

3. Press the MENU switch (6) until the SPLIT NO. indicator (11) is illuminated. "1" will then appear in the display screen

(5). Then, while pressing the STEP BACK switch (17), turn the dial (12) to change the contents appearing on the
display screen (5) in order.

(Example)

If three patterns have been programmed for split sewing, the number on the display screen changes in
the following order:    "1"            “2"            "3"            "1"            "2" ...

4. When the starting switch is pressed, only the pattern displayed on the display screen (5) will be sewn.

Note

As to split sewing, refer to the instruction manual of the “electronic programmable pattern tacker programmer”.

(12)

(6)

(5)

1215S

1225S

1224S

(17)