7. SEWING; 7-1. Before starting sewing....; 7-2. Sewing operation- Page 34

7. SEWING

BAS-341F,342F

27

7. SEWING

CAUTION

Turn off the power switch at the following times, otherwise the machine may operate if the foot switch is
depressed by mistake, which could result in injury.

• When replacing the bobbin and needle

• When not using the machine and when leaving the machine unattended

Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result
in personal injury or damage to be machine.

7-1. Before starting sewing....

•

Check that the needle bar is at the highest position.

Turn the machine pulley so that the index mark (1) on
the pulley is almost aligned with the point where belt
cover U and belt cover D meet.

   
*

If the machine is started while the index mark (1) is not
correctly aligned, error message "E-22" will be
displayed (only when memory switch No.14 is on).

7-2. Sewing operation

1. Turn the power switch on.

(The power indicator on the operation panel will light.)

2. Insert the floppy disk (3).
3. Press the PRO. No. selection switch (4) to select the

desired program number.

4. Press R/W switch (5).

The floppy disk drive indicator will light and the
PROGRAM NO. display (6) will show a “P” while
the data is being read. When reading is completed,
an alarm will sound and the indicator will go out,
then the PROGRAM NO. display (6) will blink the
program number.

1944S

1213S

1229S

(3)

(6)

(4)

(5)