Press .; If the Bobbin Runs Out of Thread ; Unlock the frame-securing lever and - Page 237

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

Embr
oi

de
ry

223

5

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

If the Bobbin Runs Out of Thread 

When the bobbin begins to run out of thread 
during embroidering, the machine will stop and 

the message below will appear. Press 

 and 

follow the directions below to rethread the lower 
threading. If very little sewing remains, you can 
embroider 10 final stitches without rethreading the 
machine by pressing 

. The machine will stop 

after sewing the 10 stitches.

a

Press .

o

After the thread is automatically cut, the carriage 
will move.

b

Unlock the frame-securing lever and 
remove the embroidery frame.

*

Be careful not to apply strong force to the fabric at 
this time. Otherwise, the fabric may loosen in the 
frame. 

c

Insert a wound bobbin into the machine. 
(see page 43 for Setting the bobbin.)

d

Press .

o

The carriage will return to its original position.

e

Attach the embroidery frame.

f

To return to the spot in the pattern where 

you stopped sewing, follow steps 

c

through 

f

 in the next section.

Note

• Be careful not to bump the embroidery unit carriage or the presser foot when removing or attaching the 

embroidery frame. Otherwise, the pattern will not embroider correctly. 

Note

• If “Upper and Bobbin Thread Sensor” in the 

General settings screen of the machine 
setting mode is set to “OFF”, the message 
shown above does not appear.