Insert the two thumb screws at the bottom ; of the cap frame driver into the v-cuts in the ; carriage, and then place the mounting plate - Page 230

APPENDIX 

————————————————————————————————————————————————————————————————————————————

228

4

Insert the two thumb screws at the bottom 
of the cap frame driver into the v-cuts in the 
carriage, and then place the mounting plate 
of the cap frame driver on top of the frame-
mounting plate of the carriage.

1

Notch in the carriage

2

Thumb screw of the cap frame driver

3

Mounting plate of the cap frame driver

4

Frame-mounting plate of the carriage

5

Insert the pins on the frame-mounting plate 
of the carriage into the holes in the 
mounting plate of the cap frame driver.

1

Pins on the frame-mounting plate of the 
carriage

2

Holes in the mounting plate of the cap frame 
driver

6

Insert and tighten the two upper thumb 
screws in outer holes of mounting plate of 
cap frame driver.

7

While pushing in the cap frame driver 
toward the machine so that it is fully 
inserted, tighten the two lower thumb 
screws to secure the cap frame driver.

X

This completes the installation of the cap 
frame driver.

■

Adjusting the cap frame driver

1

L-shaped bracket

2

Ring

Memo

●

If the same machine is being used, the 
adjustment to the cap frame driver is only 
required the first time that the machine is 
used.

1

Turn on the machine. After the carriage 
moves to its initial position, turn off the 
machine.

Note

●

Be sure to adjust the cap frame driver with 
the carriage at its initial position.