Securely clamp the mounting bracket onto ; the mounting surface by tightening the ; Check that there is no looseness.- Page 233

Using the Optional Cap Frame

 231

7

—————————————————————————————————————————————————————————————————————————————————————

4

Securely clamp the mounting bracket onto 
the mounting surface by tightening the 
thumb screw.

1

Mounting bracket

2

Mounting surface

3

Tighten thumb screw

Memo

●

If there is a gap between the clamping pad 
of the thumb screw and the mounting 
surface, insert the included pad as shown 
below.

1

Mounting bracket

2

Mounting surface (worktable, desk, etc.)

3

Pad

4

Thumb screw

5

Check that there is no looseness.

If there is looseness, mount the mounting jig 
onto the mounting surface again.

Note

●

Be sure that the mounting bracket is 
securely clamped onto the mounting 
surface and that the thumb screw is firmly 
tightened.

●

Do not attach the mounting jig to an 
unstable surface (flexible, bent or warped).

●

Be careful that the mounting jig does not 
fall when it is removed.

6

Adjust the size of the mounting jig according 
to the type of cap being embroidered.

1

Low Profile (Low fitting)

2

Standard type (Pro style)

■

For the standard type

Using a Phillips screwdriver, turn the four 
screws (two on the left and two on the right) at 
the inside of the mounting jig one turn to loosen 
them.

1

Screws

2

Phillips screwdriver

Note

●

Do not remove any of the four screws (two 
on the left and two on the right); 
otherwise, they may be lost. Only turn the 
screws to slightly loosen them.