Threading the needle; Pull the end of the thread, which has been ; passed through the needle bar thread guide, - Page 33

Upper Threading    

 27

1

Threading the needle

Memo

●

The needle threader can be used with 
sewing machine needles 75/11 through 
100/16.

●

The needle threader cannot be used with 
the wing needle or the twin needle.

●

If the needle threader cannot be used, refer 
to “Threading the needle manually (without 
using the needle threader)” on page 28.

1

Pull the end of the thread, which has been 
passed through the needle bar thread guide, 
to the left, then pass the thread through the 
notch of the thread guide 

1

, and then firmly 

pull the thread from the front and insert it into 
the slit of the thread guide disk marked “7” all 
the way 

2

.

Make sure that the thread passes the notch of 
the thread guide.

1

Notch of the thread guide

2

Thread guide disk

2

Cut the thread with the cutter on the left side 
of the machine.

1

Thread cutter

3

Lower the presser foot lever.

1

Presser foot lever

X

The presser foot is lowered.

4

Lower the needle threader lever until it clicks.

1

Needle threader lever

X

The thread is passed through the eye of the 
needle.

5

Release the needle threader lever.

6

Carefully pull on the loop of thread passed 
through the eye of the needle to pull out the 
end of the thread.

7

Raise the presser foot lever, pass the thread 
through the presser foot, and then pull out 
about 5 cm (2 inch) of thread toward the rear 
of the machine.

X

The upper threading is finished.

Now that the upper threading and the lower threading 
are finished, you are ready to begin sewing.

1

2

2

1

5

1

1

5 cm (2 inch)

1

1

1