3-8. Installation of the folding group assembly; 3. Installation- Page 14

7

BAS-761

3-8. Installation of the folding group assembly

Before installation

¡

Apply air pressure.

¡

Turn on power switch 

q

 to return the machine to the home position.

¡

Turn valve switch 

w

 to OFF (lower) side and "E-820" will flash on the display.

1.

Install folding clamp assembly 

e

 onto folding base 

r

.

2.

Attach multi-connector 

t

.

3.

While pushing the folding clamp assembly 

e

 downwards with your hand, install the inner clamp assembly 

y

 to

the folding base 

r

. For models with a label attachment device 

u

, install the plug 

i

 of the label attachment device

u

 to the socket 

o

.

At this time, set the label attachment device 

u

 so that it is in a ready condition on top of the inner clamp assembly.

(Refer to page 27.) If it is reversed, it will turn downward.

4.

Install center blade assembly 

!0

 on folding base 

r

.

5.

Install sewing clamp assembly 

!1

 on sewing clamp assembly arm base 

!2

.

6.

Install the multi-connector 

!4 

and the dual sensor harness assembly 

!3

.

7.

Set the valve switch 

w

 to ON (up position).

The "E-820" indication will disappear from the display panel and the panel will return to its previous condition.

8.

Move folding clamp assembly 

e

, inner clamp assembly 

y

, center blade assembly 

!0

 and sewing clamp assembly

!1

 back and forth, and right and left, to ensure they are secured.

o

i

t

w

r

!0

q

!1

!3

u

y

e

@1

!4

3. Installation

!2