11. Using the DIP switches- Page 43

36

BAS-761

No.

1

2

3

4

5

6

7

8

Functions when ON

In automatic, pattern matching and label attachment modes, the work clamp stops momentarily before
feeding to the home position.

Low feeding speed (Machine head 

→

 Folder)

Low feeding speed (Folder 

→

 Machine head)

Not available (Should be set to OFF)

Not available (Should be set to OFF)

Not available (Should be set to OFF)

After the power is turned on, three pockets are sewn at 3,000 rpm.

Machine head operation check, stacker operation check

11. Using the DIP switches

11. Using the DIP switches

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall
outlet before opening the face plate of the control box. Touching areas where high voltages are present can
result in severe injury.

 DANGER

Note:

¡

Always be sure to turn the power OFF when changing the settings of the DIP switches.

¡

The functions of the DIP switches are subject to changes without notification.

¡

If DIP switches B-1 to B-6 are ON, be sure to check the cylinder movement and data version thoroughly. In some
cases a peculiar error may be displayed.

■

 DIP switch positions

■

 Functions of operation panel DIP switches

¡

DIP switch A

■

 Functions of DIP switches on main circuit board

¡

DIP switch B

No.

1

2

3

4

5

6

7

8

Functions when ON

Mismatches between folder numbers and program numbers are ignored

Clamp vertical sensor is ignored

Needle racking cylinder sensor is ignored

Double cylinder sensor is ignored

24 V/36 V power supply voltage check is ignored

Single and double clamp data check is ignored

Not available (Should be set to OFF)

Not available (Should be set to OFF)

DIP switch A

DIP switch B

DIP switch C

DIP switch D

DIP switch E