How to load paper; To load paper or other media in the paper tray; Introduction- Page 23

Introduction

1 - 10

1

How to load paper

To load paper or other media in the 
paper tray

1

Pull the paper tray completely out of the 
DCP.

2

While pressing the paper guide release 
lever, slide the adjusters to fit the paper 
size.
Check that the guides are firmly in the 
slots.

Note

For Legal size paper, pull out the back of the 
paper tray while holding the inside latch of the 
tray.

3

Fan the stack of paper well to avoid 
paper jams and mis-feeds.

4

Put paper in the paper tray.

5

Put the paper tray firmly back in the DCP 
and unfold the output paper tray support 
flap before you use the DCP.

Note

When you put paper in the paper tray, please 
remember the following:

■

Check that the paper is flat in the tray and 
below the maximum paper mark, and that 
the paper guides are touching the sides of 
the paper stack.

■

The side to be printed on must be face 
down.

Maximum Paper Mark

Output Paper 
Tray Support 
Flap