5 - 1
5
5
Federal Communications
Commission (FCC)
Declaration of Conformity
(USA only)
Responsible Party:
Brother International Corporation
100 Somerset Corporate Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700
declares, that the products
Product Name: Laser DCP, DCP-7020
comply with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This
device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
ā
Reorient or relocate the receiving antenna.
ā
Increase the separation between the
equipment and receiver.
ā
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
ā
Call the dealer or an experienced radio/TV
technician for help.
Important
Changes or modifications not expressly approved
by Brother Industries, Ltd. could void the userās
authority to operate the equipment.
Important - about the interface cable
A shield interface cable should be used to ensure
compliance with the limits for a Class B digital
device.
Important information
WARNING
ā
This DCP has been certified to comply with
FCC standards, which are applied to the
USA only. A grounded plug should be
plugged into a grounded AC outlet after
checking the rating of the local power
supply for the DCP to operate properly and
safely.
ā
For protection against the risk of electrical
shock, always disconnect all cables from
the wall outlet before servicing, modifying
or installing the equipment.
WARNING
Brother cannot accept any financial or other
responsibilities that may be the result of your
use of this information, including direct, special
or consequential damages. There are no
warranties extended or granted by this
document.