8.4.11 Fine Adjustment of Scan Start/End Positions (Function code 54); Procedure ; Fine Adjustment of Scan Start/End Positions (Function code 54) - Page 179

  8 - 2 2  

Confidential

8.4.11 

Fine Adjustment of Scan Start/End Positions (Function code 54)                                  

(Not applicable to DCP7010/7020/7025)

„

 Function 

This function is to adjust the scan start/end positions. 

„

 Operating 

Procedure 

(1) Press the 

5

 and 

4

 keys in this order in the initial stage of the maintenance mode. 

The “SCAN START ADJ.” will appear on the LCD. 

(2)  The “1. ADF 2. FB” will appear. 

Select one of them that you want to adjust the start position.   

If you want to adjust the start position of the ADF, press 

1

 key, and if you want to 

adjust that of the FB unit, press 

2

 key. 

(3)  The present compensation level for the start position appears on the LCD. 

Compensation levels can be adjusted in 11 steps from +5 to –5 (mm). 

(4) Press the   key to increase compensation levels, and the   key to lower them. 

Press the 

Stop/Exit

 key, and the machine returns to the initial state of the maintenance  

mode without adjusting compensation levels. 

(5) Press the 

Menu/Set

 key. 

The “ACCEPTED” will appear on the LCD. One second later, the machine “1. ADF_2. 
FB “ will appear on the LCD. 

(6) Press the 

Stop/Exit

 key when finish the adjustment. The machine returns to the initial 

state of the maintenance mode. 

NOTE:

 The correlation between the scan start/end positions and compensation levels is  

shown next page.