Job Cancel- Page 190

Confidential

9-2

ERROR MESSAGE 

CAUSE 

ACTION 

Print data is left in the MFC’s  
memory. 

Re-start printing from your computer. 

Data Remaining 

Print data is left in the MFC’s  
memory.  The USB cable was  
unplugged while the computer was  
sending the data to the MFC. 

Press 

Job Cancel

.  The MFC will  

cancel the job and clear it from the  
memory. 

Disconnected 

The other person or other person’s  
fax machine stopped the call. 

Try to send or receive again. 

Dust on Drum 

The drum unit needs to be  
cleaned. 

Cleaning the drum unit. 

DR Mode in Use 

The MFC is set to Distinctive  
Ring mode.  You can not change  
the Receive Mode from Manual to 
another mode. 

Set Distinctive Ring to Off. 

Unit is too Hot 

The fuser unit is too hot. 

Fail to Warm up 

The fuser unit is too cold. 

(For MFC-7420) 
When you turn off the MFC’s power  
switch its memory will be cleared. 
If there are faxes, you need to save  
them before following the suggestions 
below. 
Then, turn off the MFC’s power  
switch.  Check the MFC’s  
environment.  If it is in a location that  
is too hot or too cold, try to cool or  
warm the room by turning on the air  
conditioner or heater.  Or, move the  
MFC to another location.  Then, turn  
on the MFC’s power switch. 
(For MFC-7820N) 
Turn off the MFC’s power switch, and  
check the MFC’s environment.  If it is  
in a location that is too hot or too cold,  
try to cool or warm the room by turning 
on the air conditioner or heater. 
Or, change the location.  Then, turn on 
the MFC’s power switch. 
(The MFC can be turn off for up to 4  
days without losing faxes stored in the  
memory.)