Preparation ; Start ; If you use USB cable - Page 254

  Ap p .  

2 -3  

Confidential

„

If you use USB cable 

Preparation 

You need to have the BHL2-Maintenance Printer driver and FILEDG32.exe (provided by Brother  
Industries) on hand. Save them in an arbitrary folder in your PC. 

Installing the BHL2-Maintenance Printer driver 

To identify terminals connected via USB interface, a PC requires the corresponding virtual USB  
devices to be implemented by driver/software.  If you connect any number of machines to your PC,  
therefore, the same number of virtual USB devices will be automatically configured on your PC.  
To prevent virtual USB devices from being configured limitlessly, use the unique driver  
installation procedure described below that enables your PC to identify terminals via a single  
virtual USB device. 

NOTE:

 Once this installation procedure is carried out for a PC, no more driver/software  

installation will be required for that PC to identify machines. If the BHL2-Maintenance  
Printer driver has been already installed to your PC according to this procedure, skip this  
section. 

NOTE:

 Before proceeding to the procedure given below, make sure that the BHL2-Maintenance  

Printer driver is stored in your PC. 

(1)  Make sure that the power cord of the machine is unplugged from the electrical outlet. 

If the machine is connected to a PC, unplug the USB cable. 

(2)  Switch on your PC. 

(3)  Plug the power cord of the machine into an electrical outlet. 

(4) Press the 

Menu/Set

 and 

Black

Start 

keys. Next press the   key four times to make the 

machine enter the maintenance mode. (Refer to 

Chapter 8

.) 

TIP:

 FAX models equipped with numerical keypads can enter the maintenance mode in the  

same way as conventional models; that is, by pressing the 

Menu/Set

, 

*

, 

2

, 

8

, 

6

 and  

4

 keys in this sequence. 

(5)  Connect the machine to your PC using the USB cable. 

The following window appears.