4. COMMAND SYNTAX; 4.1. Mnemonic; 4.2. Parameters- Page 165

CHAPTER 4 HP-GL/2 - 9 

4.

COMMAND SYNTAX 

An HP-GL and HP-GL/2 command can consist of up to four items:    a mnemonic, a parameter field, a 
separator and a terminator. 

4.1.

Mnemonic 

The two-letter mnemonic is the name of the command and should help remind you of its function. 

4.2.

Parameters 

Some commands have parameters following the instruction mnemonic.    Multiple parameters must have 
separators between them.    Parameters are shown in italics.    Optional parameters are surrounded by square 
brackets.    Parameters that can be repeated are followed by "...". 



Integer - integers are allowed in the range -2

30

 and 2

30

 - 1.    Real numbers specified for a parameter that 

should be an integer are rounded to the nearest integer. 



Clamped integer - integers are allowed in the range -32768 and 32767.    Parameters outside this range are 
converted (clamped) to the nearest integer within the range,    for example 40,000 will be clamped to 32767.   
Non-integers are converted to the nearest integer. 



Real number - real numbers whose integer part is in the range -2

30

 to 2

30

 - 1.    Accuracy to at least 6 

significant digits is guaranteed.    If a number outside the range is specified the entire command is ignored.   
The decimal point can be omitted when the number has no fractional part. 



Clamped real number - real numbers whose integer part is in the range -32768 to 32767.    Parameters 
outside this range are converted (clamped) to the nearest real number within the range.    The decimal point 
can be omitted when the number has no fractional part. 

Text parameters are referred to as labels and can consist of any sequence of characters. 

4.3.

Separators 

If an HP-GL/2 instruction accepts more than one parameter, you must put spaces or a comma between the 
parameters to separate them. 

4.4.

Terminator 

Most commands are terminated implicitly by the first letter of the next instruction mnemonic.    A semi-colon 
may be used to explicitly terminate a command.    However,    the final command issued before quitting HP-
GL/2 mode must be terminated with a semi-colon.    Since a terminator is almost always optional it is shown 
surrounded by square brackets.