Windows® 2000/XP Printing (Printer Driver already installed); Windows NT®4.0 Printing; 4.0 Printing- Page 28

TCP/IP PRINTING 2 - 4

Windows

®

 2000/XP Printing (Printer Driver 

already installed)

If you have already installed the printer driver and wish to configure 
it for network printing, follow these steps:

1

Select the printer driver you wish to configure.

2

Select File and then choose Properties.

3

Click the Ports tab of the driver and click Add Port.

4

Select the port that you wish to use. Typically this would be 
Standard TCP/IP Port. Then click the New Port... button.

5

The standard TCP/IP Port Wizard will start. Follow steps 6-10 
of the “Standard TCP/IP Port Printing” section.

Windows NT

®

4.0 Printing

If you did not install the TCP/IP protocol during the installation of your 
Windows NT

®

4.0 system (either workstation or server) follow these 

steps. If you have already installed the TCP/IP protocol, proceed to 
the next section.

1

Go to the Start button, choose Settings, and then select 
Control Panel.

2

Run the Network applet by double clicking the Network icon 
and then click on the Protocols tab.

3

Select Add, and double click on the TCP/IP Protocol.

4

Insert the requested disk(s), or CD-ROM, to copy the required files.

5

Click the Close button. The Windows NT

®

4.0 system will review 

protocol bindings and then you will see the TCP/IP Properties 
dialog.

6

Configure the host IP address, subnet mask, and gateway address 
in that dialog. Consult your system manager for these addresses.