Print Server Configuration Using BRAdmin; Banyan Vines; File Server User - Page 120

BANYAN VINES NETWORK CONFIGURATION 10 - 5

YL4US_FAX2800MFC4800-FM5.5

Print Server Configuration Using BRAdmin

The last step is to add the StreetTalk login name to the Brother print 
server and to associate the file server queue with one of the services 
on the print server. The procedure is as follows:

1

Start the BRAdmin software.

2

Select the node name of the desired Brother print server from 
the list and double clicking on it (the default node name is  

BRN_xxxxxx

, where 

xxxxxx

 is the last six digits of the 

Ethernet address (MAC address)). You are prompted for a 
password. The default password is 

access

.

3

Click on the Banyan Vines tab.

4

The Banyan hop count is set by default to two hops, which is 
adequate for most networks. However, if the file server is 
located more than two hops from the print server, you must set 
the hop count to the appropriate value.

5

Enter the StreetTalk name of the print server (this must exactly 
match the name you entered in Step 3 of the File Server User 
Console section). If the SteetTalk name has spaces in it, you 
must enclose the name in double quotation marks (for example, 

"john smith@uc_engineering@irvine"

). If you entered a 

password in the File Server User Console section, you should 
also enter the same password here.

6

Click the Services tab.

7

Double click on the service you wish to enable for VINES. If in 
doubt, use BINARY_P1. Refer to Appendix of the manual for 
additional information on using services.

8

Type in the StreetTalk name of the print queue you defined in 
step 3 of the File Server Queue Configuration section.

9

Click on OK, and then click OK again to save the configuration.

10

Click OK and then OK again to exit BRAdmin.