Print Server Configuration Using the Print Server Console; Print Server Configuration Using the Print Server - Page 121

10 - 6 BANYAN VINES NETWORK CONFIGURATION

YL4US_FAX2800MFC4800-FM5.5

Print Server Configuration Using the Print Server 
Console

As an alternative to BRAdmin, you may use the print server console 
to configure the print server. The steps are as follows:

1

Connect to the print server console using TELNET, NCP, 
BRCONFIG Execute some or all of the commands detailed 
below (you must minimally enter the StreetTalk login name of 
the print server and associate one of the print server services 
with the StreetTalk name of a print queue). 

SET BAnyan LOgin loginname

Sets the StreetTalk login name of print server.

SET BAnyan PAssword password

Sets the login password of print server. The password (if any) must 
match the password you specified in step 3 of the File Server User 
Console section.

SET SERVIce service STreettalk queuename

Enables the Banyan protocol on the specified Brother print server 
service and associates this service with the StreetTalk name of a 
given print queue on the VINES file server. Type 

SHOW SERVICE

 to 

see a list of the available services (if in doubt, use BINARY_P1).

SET BAnyan HOp nn

Sets number of hops between the Brother print server and the 
Banyan file server. The default value is 2, which is adequate for most 
sites, but you will need to change this value if the file server is more 
than two hops away from the print server.
When you have finished entering commands, type EXIT to exit the 
remote console and cause the commands to take effect.