Troubleshooting; Overview; Installation problems- Page 137

13 - 1 TROUBLESHOOTING

13

YL4US_FAX2800MFC4800-FM5.5

13

Troubleshooting

Overview

This chapter describes procedures for troubleshooting problems you 
may encounter with a Brother print server, it is divided into the 
following sections: 

1

Installation Problems

2

Intermittent Problems  

3

Protocol-Specific Troubleshooting

Installation problems

If you cannot print over the network, check the following:

1

Make sure that the printer is powered on, is on-line and ready to 
print.

Verify that the printer and the configuration are good by printing 
the configuration page. Refer to the Quick Setup Guide. If the 
test fails, check:

a

If the LED is not blinking after connected to the network, then 
the network firmware settings may be corrupted. Please refer 
to Step 3.

b

In this event, try to restore the factory default settings of the 
print server by pressing the TEST switch on the back panel of 
the printer for longer than 5 seconds. Once you have done 
that, switch the printer off and then on again, and try to print 
out the configuration page.

2

If the configuration page prints but you cannot print documents, 
try the following 

If none of the following steps are successful, there is almost 
certainly a hardware or network problem!