2 Configuring your network printer; Overview; IP addresses, subnet masks and gateways- Page 19

Brother MFC-8660DN Network User's Guide

Table of Contents

Network USER’S GUIDE
background image

2

 7

2

Configuring your network printer

Overview

Before you can use your Brother machine on your network, you need to install the Brother software and also 
configure the appropriate TCP/IP network settings on the machine itself. To do this, we recommend that you 
use the automatic installer on the Brother CD-ROM as this will guide you through the software and network 
installation. 

If you do not wish to use the automatic installer, or you do not understand some of the terms used by the 
automatic installer, refer to the remainder of this chapter for more information.

Note

If you do not wish to, or are unable to use the automatic installer or any of Brother’s software tools, you can 
also use the machine’s control panel to change network settings. For more information, see 

Control Panel 

Setup on page 13.

IP addresses, subnet masks and gateways

To use the machine in a networked TCP/IP environment, you need to configure its IP address and subnet 
mask. The IP address you assign to the print server must be on the same logical network as your host 
computers. If it is not, you must properly configure the subnet mask and the gateway address.

IP address

An IP address is a series of numbers that identifies each device connected to a network. An IP address 
consists of four numbers separated by dots. Each number is between 0 and 255.

Example: In a small network, you would normally change the final number.

192.168.1.1, 192.168.1.2, 192.168.1.3

If you have a DHCP/BOOTP/RARP server in your network (typically a UNIX

®

/Linux, Windows

®

 2000/XP, 

Windows Vista

®

 network) the print server will automatically obtain its IP address from the DHCP server.

Note

On smaller networks, the DHCP server may be the Router.

For more information on DHCP, BOOTP and RARP, see 

Using DHCP to configure the IP address on page 

88, 

Using BOOTP to configure the IP address on page 89 and Using RARP to configure the IP address on 

page 89.

Detailed Information for Brother MFC-8660DN Network User's Guide

Lists of information found in Brother MFC-8660DN Network User's Guide - Page 19

  • 13. IP addresses, subnet masks and gateways To use the machine in a networked TCP/IP environment, you need to configure its IP address and subnet mask.
  • 55. Example: In a small network, you would normally change the final number.
  • 92.168.
  • 1.1, 192.
  • 68.1.
  • 92.168.
  • 1.3 If you have a DHCP/BOOTP/RARP server in your network (typically a UNIX ® /Linux, Windows ® 2000/XP, Windows Vista ® network) the print server will automatically obtain its IP address from the DHCP server.

Related Documents for Brother MFC-8660DN Network User's Guide