䈀䄀刀 吀䄀䌀䬀䤀一䜀; BAR TACKING- Page 54

51

Contents

Setting Up

Basic Sewing

Machine

Operation

Utility Stitches

Embroidering

Maintenance

Troubleshooting

Error

Messages

Sewing Chart

Patterns

(Programmed

in Machine)

Patterns

(Memory Card)

BAR TACKING

A

1. Attach presser foot “A” and set the size by measuring the area

to be bar tacked.

1

Scale

2

0.5 cm (13/64”)

3

Length of bar tack

*

0.5 to 3 cm (13/64” to 1-3/16”) is suitable for bar tacking.
0.5 to 1 cm (13/64” to 3/8”) is the normal size.

Use for reinforcing the openings of pockets, etc.

1

1

Bar tack

2. Position the pocket as illustrated with the top of the pocket

facing you.

CAUTION
–

After the presser foot lever has been lowered,
set the presser foot so that there is no gap be-
hind the section marked with an “A”, otherwise
the size of the stitch will not be correct. To do
this, push the presser foot towards the back of
the machine as shown in the figure.

–

Pass the thread underneath the presser foot.

3

5

3. Check the first needle drop point and lower the presser foot.

1

2 mm (5/64”)

4. Lower the buttonhole lever and position it behind the metal

bracket on the buttonhole foot.

1

Metal bracket on buttonhole foot

3

5

A

1

2

3

1

1