Tab ; Error Message- Page 57

49

EEPROM
ERROR!

This message appears if a checksum 
error occurred when the P-touch was 
turned on or if the keyword was dam-
aged and it failed to initialize.

Contact your service representa-
tive.

INTERFACE
ERROR!

This message appears if an error 
occurs while data is being sent from 
the computer to the P-touch.

Cancel the print job, and then 
try printing again.

INVAL.
CHRS!

This message appears if the cursor is 
not below a number when you hold

down 

c

 and press 

O

.

Move the cursor below a num-
ber before holding down

c

 and pressing 

O

.

LENGTH
LIMIT!

• This message appears if the text is 

longer than 3’ 3 1/3” (1 meter) when 
you try to print.

• Shorten the text to less than 3’ 

3 1/3” (1 meter) before trying 
to print.

• This message appears if the 

Length

function is used to set a label 
length that is less than 1.6” (4.0 
cm) or more than 11.8” (30.0 cm).

• Set the label length between 

1.6” (4.0 cm) and 11.8” (30.0 
cm). 

• This message appears if the 

Tab 

Length

 function is used to set a tab 

length that is more than 11.8” 
(30.0 cm).

• Set the tab length so that it is 

less than 11.8” (30.0 cm).

LINE
LIMIT!

This message appears if the number 
of lines in the text is greater than the 
maximum number of lines possible 
for the installed tape.

Reduce the number of lines or 
install a tape of greater width.

MEMORY
FULL!

This message appears if you try to 
store a text file after the maximum 
number of characters has already 
been stored in the memory.

Delete an unwanted file to make 
room for the new one.

NO
FILES!

This message appears if you try to 
recall or delete a text file from the 
memory when none are stored.

Store a text file first.

NO
TAPE!

This message appears if you try to print 
a label or feed the tape when no tape 
cassette is installed.

Install a tape cassette and try 
again.

Error Message

Cause

Remedy