Possible Cause; The P-touch labeler ; stops while printing a - Page 70

TROUBLESHOOTING

64

What to do when...

The P-touch labeler 
stops while printing a 
label.

Is there enough tape 
remaining in the tape 
cassette?

The striped tape indicates 
you have reached the end of 
the tape. Replace the tape 
cassette when the striped 
tape appears.

Are the batteries weak and 
the AC adapter not 
connected or is the AC 
adapter the Brother AD-24?

Replace all batteries or 
connect the AC adapter 
(Brother AD-24) directly to 
the P-touch labeler.

The label is not cut 
automatically.

Is Cut Option set to Chain or 
No Cut?

When these options are set, 
the tape is not fed after 
printing the label. Check the 
Cut Option setting, or hold 
down the 

 key and press 

the 

 key to feed and 

cut the tape.

Is Manual Cutting set to ON?

When using Fabric Iron-On 
Tapes or  Extra Strength 
Adhesive Tapes, please use 
scissors to cut the tape after 
printing.

Does the tape compartment
cover open?

If so, close the tape
compartment cover 
correctly.

Label files saved 
previously are now 
empty.

Have the batteries and AC 
adapter been disconnected?

All files stored in the internal 
memory is lost if the 

batteries

 and AC adapter are 

disconnected for longer than 
two minutes.

Is there enough power 
remaining in the batteries?

All data stored in the internal 
memory is lost if the 
batteries become empty.

Have you used the Reset 
function?

The reset function clears all 
data stored in the internal 
memory, including label 
files.

Problem

Possible Cause

Recommendation