On a Macintosh Computer; 1 Check that your system configuration meets the following requirements.; 2 Connect the PT-2300/2310 to the Macintosh using a USB interface cable. Be sure to leave the PT-...- Page 21

17

On a Macintosh Computer

The Mac version of the software is for a Mac with an English operating system. If the software is
installed on a Mac with an operating system in a different language, the software may not run properly.

To Install the P-touch Editor Software:

1

Check that your system configuration meets the following requirements.

Computer:

 Macintosh, Power Macintosh or iMac

Operating system:

 Mac OS 8.6 or later

*This software is only compatible with Mac OS X classic.

Hard disk free space:

 At least 20 MB

☞

A few hundred megabytes of additional free space may be needed when printing
long labels or large amounts of data.

Available memory free space:

 Minimum 24 MB

USB port
CD-ROM drive

*The application is supplied on a CD-ROM; therefore, the computer should be equipped

with a CD-ROM drive.

2

Connect the PT-2300/2310 to the Macintosh using a USB interface cable. Be sure to leave
the PT-2300/2310 turned off.

3

Turn on the Macintosh.

4

Insert the P-touch Editor Version 3.1 CD-ROM into the computer’s CD-ROM drive.

5

Double-click the P-touch Editor 3.1
Installer icon in the folder that appears.

6

After the installer starts up, select the
installation method.

• For a Basic Installation

Clicking the Install button immediately
starts installing the most basic options.
(Some clip art illustrations are not
installed.)
About 20 MB of available hard-disk
space is needed to begin installation. In
order to install all options, about 120
MB of available hard-disk space is
needed. If enough hard-disk space is
available, click the Install button.