Error Message; REPLACE ; SOLDER X- Page 72

68

NO
TAPE!

This message appears if you try to print 
a label or feed the tape when no tape 
cassette is installed.

Install a tape cassette and try 
again.

REPLACE 
BATTERIES!

This message appears if the installed 
alkaline batteries are about to run 
out.

Replace the batteries or use the 
AC adaptor.

ROM
PROBLEM!

This message appears if there is a 
problem with the machine’s read 
only memory.

Contact your service representa-
tive.
Turn off the machine, and then 

while holding down 

c

 and 

R

, turn the machine back on. 

SOLDER X

This message appears if there is a
problem with the machine’s software.

Contact your service representa-
tive.

TAB
LIMIT!

This message appears if the maximum 

number of tabs has already been added 

to the text when you hold down 

c

and press 

Q

.

Limit the number of tabs in the
text to 50.

TEXT
TOO HIGH!

This message appears if the size of
the text is larger than the width of the
installed tape.

Reduce the size of the characters
or install a wider tape.

TEXT
TOO LONG!

This message appears if the length of 
the text is longer than the label length 
that has been set using the 

Length

function.

Delete some of the text, reduce
the character width or increase
the set label length.

Error Message

Cause

Remedy