Error Message; CAN’T ; WHOLE CODE- Page 123

116

CAN’T 
HERE!

This message appears if the cursor is
at the end of the text when you hold 

down 

c

 and press 

O

.

Move the cursor below a
number before holding down 

c

 and pressing 

O

.

CASSETTE
CHANGED!

This message appears if the tape cas-
sette is changed while the P-touch is 
receiving data from the computer.

Cancel the print job, install the 
correct tape cassette, and then 
try printing again.

CHANGE
ADAPTOR!

This message appears if a high-volt-
age adapter is being used.

Remove the high-voltage 
adapter and connect the adapter 
designed exclusively for this 
machine.

CUTTER
ERROR!

This message appears if the tape cut-
ter is closed when you try to print or 
feed the tape.

Turn the P-touch off, then on 
again.

EEPROM
ERROR!

This message appears if a checksum 
error occurred when the P-touch was 
turned on or if the keyword was dam-
aged and failed to initialize.

Contact your service representa-
tive.

FEED
ERROR!

This message appears if the AV label 
sensor cannot detect the labels.

• Replace the AV label cassette 

with one that is not empty.

• If this error message appears 

even after a new AV label cas-
sette is installed, the sensor 
may be damaged. Contact 
your service representative.

INPUT
WHOLE CODE

This message appears if the set 
number of digits is not entered in the 
barcode data.

Input the correct number of dig-
its or change the number of dig-
its set in the barcode parameters.

Error Message

Cause

Remedy