Tab ; Error Message- Page 124

117

INTERFACE
ERROR!

This message appears if the wrong 
port is selected.

Windows

®

Under “Print to the following 
port” in the printer Properties 
dialog box, select “PTUSB:” for 
the USB connection.

☞

If two or more of the same
P-touch models are con-
nected through their USB
ports, instead of “PTUSB:”,
select “PTUSB (PT-
2600/2610-XXXXXXXXX):”
(where XXXXXXXXX is the
serial number). The serial
number is written above the
barcode on the silver label
attached to the bottom of
the P-touch.

Macintosh

In the Chooser, select the PT-
2600/2610 as the printer.

LENGTH
LIMIT!

• This message appears if the text is 

longer than 3’ 3 1/3” (1 meter) when 
you try to print.

• Shorten the text to less than 3’ 

3 1/3” (1 meter) before trying 
to print.

• This message appears if the 

Length

function is used to set a label 
length that is less than 1.6” (4.0 
cm) or more than 11.8” (30.0 cm).

• Set the label length between 

1.6” (4.0 cm) and 11.8” (30.0 
cm). 

• This message appears if the 

Tab 

Length

 function is used to set a tab 

length that is more than 11.8” 
(30.0 cm).

• Set the tab length so that it is 

less than 11.8” (30.0 cm).

LINE
LIMIT!

This message appears if the number 
of lines in the text is greater than the 
maximum number of lines possible 
for the installed tape.

Reduce the number of lines or 
install a tape of greater width.

MEMORY
FULL!

This message appears if you try to 
store a text file after the maximum 
number of characters has already 
been stored in the memory.

Delete an unwanted file to make 
room for the new one.

Error Message

Cause

Remedy