On a Macintosh Computer; 1 With the P-touch 2600/2610 and the Macintosh turned off, connect the P-touch to the computer us...; 2 Turn on the Macintosh.- Page 30

23

On a Macintosh Computer

The Mac version of the software is for a Macintosh with an English operating system. If the
software is installed on a Macintosh with an operating system in a different language, the soft-
ware may not run properly.

BEFORE INSTALLATION

Check that your system configuration meets the following requirements.

Computer:

 Macintosh with a Power PC processor

Operating system:

 Mac OS 8.6 to 9.X or OS X 10.1 to 10.2.1

Hard disk free space:

 At least 20 MB (100 MB to install full option)

☞

Up to 100 MB of hard disk free space may be needed when printing long labels or large
amounts of data.

Memory: 

At least 32 MB of available RAM

USB port

 (installed as standard equipment)

CD-ROM drive

* The application is supplied on a CD-ROM; therefore, the computer should be equipped

with a CD-ROM drive.

INSTALLING THE P-TOUCH EDITOR 3.2 SOFTWARE

The P-touch Editor 3.2 software includes a variety of more complex functions for printing bar-
codes and images, enabling you to design just about any label that you can image. Install the
P-touch Editor 3.2 software onto a Macintosh as described below.

1

With the P-touch 2600/2610 and the Macintosh turned off, connect the P-touch to the
computer using the enclosed USB interface cable as described on page 6. Be sure to
leave the P-touch turned off.

2

Turn on the Macintosh.

3

Insert the enclosed CD-ROM into the com-
puter’s CD-ROM drive.

4

Double-click the Mac OS 9 folder to open
it.

With a Mac OS before OS X: