Changing the P-touch settings; Changing the USB ID mode; Recognizing the PT-9500PCs individually- Page 109

108

Changing the P-touch settings

This section contains the procedures to change the PT-9500PC baud rate and an explanation for doing 
so in a LAN environment.

Changing the USB ID mode

When multiple PT-9500PCs are used, the USB 
ID mode can be changed to recognize and use 
each PT-9500PC individually or to recognize 
all of the PT-9500PCs as a single printer.

"

Recognizing the PT-9500PCs individually

If the ID mode (see back of machine) is set 
to “1,” install a separate printer driver for 
each PT-9500PC.
Each PT-9500PC will then be recognized 
as a different printer by the personal 
computer.

"

Recognizing the PT-9500PCs as a single 
printer.

If the ID mode is set to “2,” install the 
printer driver one time only and then 
multiple PT-9500PCs can be used as the 
same printer. Even if you connect a 
different PT-9500PC to the personal 
computer, the PT-9500PC can be used 
without any additional setup.

1

Turn off the PT-9500PC and the personal 
computer.

2

Remove the USB interface cable from 
both the PT-9500PC and the personal 
computer.

3

Change the USB ID switch on the back of 
the PT-9500PC.

4

Connect the USB interface cable to the 
PT-9500PC and the personal computer.

5

Turn on the PT-9500PC, and then turn on 
the personal computer.

Note

●

The USB ID switch is usually set to “2.”