Auto setting (default value); The default is “50”.- Page 52

 52 

* 0 and 1 to 4 with Micro PDF417

7. Symbol size in Y direction 
[1-byte decimal]   0 
[1-byte decimal]      3 to 90 

* 0 and 4 to 44 with MicroPDF417

Auto setting   (default value)

Manual setting

8. Aspect 

value 

[2-byte decimal]      1 to 1000 

 
Enter the aspect value. Actually, this is between 0.01 and 
10.0. However, since a decimal point cannot be entered, a 
value multiplied by 100 is entered. 

The default is “50”.

 (The actual value is 0.5.)

* Note: 

・

The aspect value setting is ignored if the symbol size in the X direction or the symbol size 

in the Y direction is entered manually. 

・

Depending on the conditions, the bar code may not be generated or a bar code that 
cannot be scanned may be generated if the symbol size in the X direction or the symbol 

size in the Y direction is entered manually. 

・

When a large cell size is specified together with a high error correction capacity, printing 
may not be possible because the print buffer has become full. 

[With symbol type Micro PDF417] 

・

Since the error correction capacity is automatically determined from the symbol size in 
the X direction, the settings for “Error correction capacity–type” and “Error correction 

capacity–value” are ignored. 

・

The aspect value setting is ignored. 

The following table shows the values available for the symbol size in the Y direction 

according to the symbol size in the X direction. If an invalid setting is specified for the 

symbol size in the Y direction, the default setting is specified. 

Symbol size in X 

direction 

Symbol size in Y direction 

AUTO

AUTO

1

AUTO

11

14

17

20

24

28

2

AUTO

8

11

14

17

20

23

26

3

AUTO

6

8

10

12

15

20

26

32

38

44

4

AUTO

4

6

8

10

12

15

20

26

32

38

44

②

 Bar code data 

The number of bar code data characters that can be entered is listed below. 

1850 alphanumeric characters, 2710 numerals, 1108 bytes of binary data 

* Note: 

The number of characters that can be entered (listed above) is for when the error correction