Setting the RD Roll; 7 Setting the RD Roll- Page 18

STEP1 Getting started

12

1

Press and hold the ON/OFF button ( ) to 

turn the TD-4000/4100N off. Pull up the left 

and right levers on the TD-4000/4100N under 

the RD Roll compartment cover, and open 

the RD Roll compartment cover.

2

Squeeze the green lever and adjust the 

guide to fit the width of the RD roll. Use the 

scale molded in the rear compartment to 

assist positioning this guide.

3

Slide the end of the RD roll under 

the gap (media) sensor.

If the end of the RD roll has not been 

fed under the gap (media) sensor, the 

TD-4000/4100N may not be able to 

detect the media properly.

4

Insert a RD roll into the roll compartment upside 

down with the labels feeding from the bottom as 

shown.

Check the position of the roll guide and adjust it to 

prevent the RD roll from moving sideways.

Incorrect insertion of the RD roll will not print on the correct 

side of the label.

7 Setting the RD Roll

Gap sensor