Headlamp Aiming; To make sure your headlamps are aimed; properly, read all the instructions before- Page 283

6-33

6. Turn the bulb socket one

-

quarter turn and 

remove it from the lamp.

7. Lift the plastic locking tab on the electrical

connector and pull the connector from the
headlamp bulb socket.

8. Connect the new headlamp bulb to the wiring

harness, making sure the connector tab snaps 
into place.

9. Insert the bulb socket into the headlamp assembly.

10. Reverse all steps to reassemble the headlamp

assembly, then check the lamps.

11. Close the hood.

Headlamp Aiming

Your vehicle has a headlamp system equipped with
horizontal and vertical aim indicators. The aim has been
pre

-

set at the factory and should need no further

adjustment. This is true even though your vertical and
horizontal aim indicators may not fall exactly on the “0”
(zero) marks on their scales.

If your vehicle is damaged in an accident, the headlamp
aim may be affected. Aim adjustment may be necessary
if it is difficult to see lane markers (for horizontal aim), 
or if oncoming drivers flash their high beams at you 
(for vertical aim). If you believe your headlamps need 
to be re

-

aimed, we recommend that you take it to 

your dealer for service; however, it is possible for 
you to re

-

aim your headlamps as described in the

following procedure.

NOTICE:

To make sure your headlamps are aimed
properly, read all the instructions before
beginning. Failure to follow these instructions
could cause damage to headlamp parts.