Finding a Station; Setting Preset Stations; P SCAN (Preset Scan):- Page 157

3-13

RECALL: Push this knob to display the station 
being played or to display the clock. To change what is
normally shown on the display (station or time), push
the knob until you see the display you want, then hold
the knob until the display flashes. Push this knob when
the ignition is off, to display the clock.

Finding a Station

AM–FM: Push this knob to switch between AM, 
FM1 and FM2. The display shows your selection.

TUNE: Turn this knob to choose radio stations.

A

 SEEK 

"

: Press the right or left arrow to go to the

next or previous station and stay there. The radio will
seek to stations with a strong signal only. The sound 
will mute while seeking.

To scan stations, press one of the SEEK arrows for 
two seconds, and SCAN will appear on the display. 
The radio will go to a station, play for a few seconds,
then go on to the next station. Press one of the SEEK
arrows again to stop scanning. The radio will scan to
stations with a strong signal only. The sound will mute
while scanning.

P SCAN (Preset Scan): Press this button to listen to
each of your preset stations for a few seconds. The radio
will go to the first preset station, play for a few seconds,
then go on to the next preset station. Press P SCAN
again to stop scanning. The radio will scan preset
stations with a strong signal only. The sound will mute
while scanning.

Setting Preset Stations

The six numbered pushbuttons let you return to 
your favorite stations. You can set up to 18 stations 
(six AM, six FM1 and six FM2) by performing the
following steps:

1. Turn the radio on.

2. Press the AM FM knob to select the band.

3. Tune in the desired station.

4. Press and hold one of the six numbered pushbuttons.

The sound will mute. When it returns, release the
pushbutton. Whenever you press that numbered
pushbutton, the station you set will return.

5. Repeat the steps for each pushbutton.