Trailer Towing; Tire Pressure Monitor; See Section 4 of your Owner Manual.- Page 23

23

Trailer Towing

The Tow/Haul mode
(if equipped) assists
when pulling a heavy
trailer by reducing the
frequency of trans-
mission shifts and
improves the control of vehicle speed.
To turn on this feature, press the 
(Tow/Haul) button located on the center
console in front of the shift lever. Press it
again to turn off the feature.

See Section 4 of your Owner Manual.

Tire Pressure Monitor

The Tire Pressure Monitor alerts you
when a significant reduction in pressure
occurs in one or more of your vehicle’s
tires by illuminating the 

(Low Tire

Pressure) warning light on the instru-
ment panel. The low tire pressure warn-
ing light will remain on until you correct
the tire pressure.
A CHECK TIRE PRESSURE message
may appear on the DIC.

Correcting the Tire Pressure

When the low tire pressure warning light
illuminates, you must inflate the tire to
the proper tire pressure. The Tire and
Loading Information label, located on
the center pillar below the driver’s door
latch, shows the correct tire pressure for
the tires when they’re cold. “Cold”
means your vehicle has been sitting for
at least three hours or driven no more
than one mile. 
You can temporarily remove the DIC
message by acknowledging it with your
DIC controls. However, at the next

vehicle start-up, the DIC message will
reappear if the tire pressure has not
been corrected.
You may notice during cooler conditions
that the low tire pressure warning light
will appear when the vehicle is first
started and then turn off as you start to
drive. This could be an early indicator
that your tire pressures are getting low
and the tires need to be inflated to the
proper pressure.

See Section 5 of your Owner Manual.

Note:

The Tire Pressure Monitor can

alert you about low tire pressure, but it
doesn’t replace normal monthly tire
maintenance.

Resetting the Oil Life System

The Oil Life System calculates engine
oil life based on vehicle use and dis-
plays CHANGE OIL SOON in the Driver
Information Center (DIC) when it’s
necessary to change your engine oil
and filter. The Oil Life System should be
reset to 100% only following an oil
change.
To reset the Oil Life System:
1. Turn on the ignition, with the engine

off.

2. Press the 

(Vehicle Information)

button until the DIC displays OIL LIFE
REMAINING.

3. Press and hold the 

(Set/Reset)

button until 100% is displayed.

4. Turn off the ignition.

See Section 5 of your Owner Manual.