Vehicle Care; Tire sealant materials are; not all the same. A non-approved- Page 370

2011 Buick LaCrosse Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

In Brief
Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
Customer Information
background image

Black plate (58,1)

Buick LaCrosse Owner Manual - 2011

10-58

Vehicle Care

The TPMS can warn about a
low tire pressure condition but
it does not replace normal tire
maintenance. See

Tire Inspection

on page 10

61

,

Tire Rotation on

page 10

61

and

Tires on

page 10

46

.

Notice:

Tire sealant materials are

not all the same. A non-approved
tire sealant could damage the
TPMS sensors. TPMS sensor
damage caused by using
an incorrect tire sealant is
not covered by the vehicle
warranty. Always use only
the GM-approved tire sealant
available through your dealer
or included in the vehicle.

Factory-installed Tire Inflator Kits
use a GM approved liquid tire
sealant. Using non-approved tire
sealants could damage the TPMS
sensors. See

Tire Sealant and

Compressor Kit on page 10

72

for

information regarding the inflator
kit materials and instructions.

TPMS Malfunction Light and
Message

The TPMS will not function properly
if one or more of the TPMS sensors
are missing or inoperable. When
the system detects a malfunction,
the low tire warning light flashes for
about one minute and then stays
on for the remainder of the ignition
cycle. A DIC warning message also
displays. The malfunction light and
DIC warning message come on at
each ignition cycle until the problem
is corrected. Some of the conditions
that can cause these to come
on are:

.

One of the road tires has been
replaced with the spare tire.
The spare tire does not have a
TPMS sensor. The malfunction
light and DIC message should
go off after the road tire is
replaced and the sensor
matching process is performed
successfully. See

TPMS Sensor

Matching Process

later in this

section.

.

The TPMS sensor matching
process was not done or
not completed successfully
after rotating the tires. The
malfunction light and the DIC
message should go off after
successfully completing the
sensor matching process.
See "TPMS Sensor Matching
Process" later in this section.

.

One or more TPMS sensors
are missing or damaged.
The malfunction light and
the DIC message should go
off when the TPMS sensors
are installed and the sensor
matching process is performed
successfully. See your dealer
for service.