Driving and Operating; Starting Procedure (Key Access); Starting Procedure (Keyless- Page 204

2015 Buick LaCrosse Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

In Brief
Seats and Restraints
Instruments and Controls
Driving and Operating
Vehicle Care
background image

Black plate (19,1)

Buick LaCrosse Owner Manual (GMNA-Localizing-U.S./Canada/Mexico-

7707475) - 2015 - CRC - 10/9/14

Driving and Operating

9-19

{

Caution

If the steering wheel is turned
until it reaches the end of its
travel, and is held in that position
while starting the vehicle, damage
may occur to the hydraulic power
steering system and there may be
loss of power steering assist.

Starting Procedure (Key Access)

1. With your foot off the accelerator

pedal, turn the ignition key to
START. When the engine starts,
let go of the key.

The idle speed will go down as
the engine warms. Do not race
the engine immediately after
starting it. Allow the oil to warm
up and lubricate all moving
parts.

{

Caution

Cranking the engine for long
periods of time, by returning the
ignition to the START position
immediately after cranking has
ended, can overheat and damage
the cranking motor, and drain the
battery. Wait at least 15 seconds
between each try, to let the
cranking motor cool down.

2. If the engine does not start after

five to 10 seconds, especially in
very cold weather (below

18°C

or 0°F), it could be flooded with
too much gasoline. Try pushing
the accelerator pedal all the way
to the floor and holding it there
as you hold the key in START
for up to a maximum of
15 seconds. Wait at least
15 seconds between each try, to
allow the cranking motor to cool
down. When the engine starts,

let go of the key, and the
accelerator. If the vehicle starts
briefly but then stops again, do
the same thing. This clears the
extra gasoline from the engine.
Do not race the engine
immediately after starting it.
Operate the engine and
transmission gently until the oil
warms up and lubricates all
moving parts.

Starting Procedure (Keyless
Access)

1. With the Keyless Access

system, the RKE transmitter
must be in the vehicle. Press the
ENGINE START/STOP button
with the brake pedal applied.
When the engine begins
cranking, let go of the button.

The idle speed will go down as
the engine gets warm. Do not
race the engine immediately
after starting it.