When replacing the battery, use care not to touch; any of the circuitry. Static from your body; transferred to these surfaces may damage - Page 69

yellow

blue     

2-13

NOTICE:

When replacing the battery, use care not to touch
any of the circuitry. Static from your body
transferred to these surfaces may damage 
the transmitter.

For battery replacement, use one Duracell

R

 battery, type

DL

-

2032, or a similar type.

To replace the battery:

1. Insert a coin into the notch near the key ring. Turn

the coin counterclockwise to separate the two halves
of the transmitter.

2. Once the transmitter is separated, use a pencil eraser

to remove the old battery. Do not use a metal object.

3. Remove and replace the battery. Replace it as the

instructions inside the cover indicate.

4. Snap the transmitter back together tightly to be sure

no moisture can enter.

5. Test the operation of the transmitter with your

vehicle. If the transmitter does not work,
resynchronize the transmitter.

Resynchronization

After replacing the battery in your transmitter, or if only
the instant alarm works, the transmitter needs to be
resynchronized to the receiver. Do this by pressing and
holding both the LOCK and UNLOCK buttons at the
same time for about eight seconds. You must be within
range of the vehicle.

Once the transmitter has been resynchronized, the horn
will chirp and the exterior lamps will flash once. The
system should now operate properly.