Playing the Radio; Finding a Station; P SCAN:- Page 163

yellow

blue     

3-11

Playing the Radio

VOLUME: This knob turns the system on and off and
controls the volume. To increase volume and turn the
radio on, turn the knob clockwise. Turn it
counterclockwise to decrease volume.

RECALL: Press the upper knob briefly to recall the
station being played or to display the clock. To change
what is normally shown on the display (station or time),
press the knob until you see the display you want, then
hold the knob until the display flashes. If you press the
knob when the ignition is off, the clock will show for a
few seconds.

Finding a Station

AM

-

FM: Press the lower knob to switch between AM,

FM1 and FM2. The display shows your selection.

TUNE: Turn the lower knob to choose radio stations.

SEEK: Press the right or left arrow to go to the next
higher or lower station and stay there. The sound will
mute while seeking.

SCAN: Press one of the SEEK arrows for two seconds,
and SCAN will appear on the display. Use SCAN to
listen to stations for a few seconds. The radio will go to
a station, stop for a few seconds, then go on to the next
station. Press one of the SEEK arrows again to stop
scanning. The sound will mute while scanning.

PUSHBUTTONS: The six numbered pushbuttons let
you return to your favorite stations. You can set up to
18 stations (six AM, six FM1 and six FM2). Just:

1. Turn the radio on.

2. Press AM

-

FM to select the band.

3. Tune in the desired station.

4. Press and hold one of the six numbered buttons. The

sound will mute. When it returns, release the button.
Whenever you press that numbered button, the
station you set will return.

5. Repeat the steps for each pushbutton.

P SCAN: Press this button to listen to each of your preset
stations for a few seconds. The radio will go to the first
preset station, stop for a few seconds, then go on to the
next preset station. Press P SCAN again to stop scanning.
The radio will not stop at a preset if the station is weak.