Lockout Protection Feature; Leaving Your Vehicle; Remote Keyless Entry- Page 67

yellow

blue     

2-7

2. On the inside of the rear door will be a lock. Insert

your key into this lock and turn it upward. This will
engage the safety lock. To disengage the feature, turn
the lock downward.

3. Close the door.

4. Do the same thing to the other rear door lock.

The rear doors of your vehicle cannot be opened from
the inside when this feature is in use. If you want to
open the rear door when the security lock is on, unlock
the door from the inside and then open the door from 
the outside.

Lockout Protection Feature

This feature prevents a driver who has left the key in the
vehicle’s ignition from locking the doors by using the
power door locks while any door is open. The feature
works by disabling the power door locks when a key is
in the ignition and any door is open.

You may override the Lockout Protection Feature by
holding the power door lock switch in the lock position
for more than three seconds while the key is in the
ignition and any door is open.

Remember, this feature can’t guarantee that you’ll never
be locked out of your vehicle. If you use the manual
door lock or if you don’t leave the key in the ignition,
you could still lock your keys inside your vehicle.
Always remember to take your keys with you.

Leaving Your Vehicle

If you are leaving the vehicle, take your keys, open your
door and set the locks from inside. Then get out and
close the door. (Also see “Delayed Locking” in this
section for more information.)

Remote Keyless Entry

You can lock and unlock your doors or unlock your
trunk from about 3 feet (1 m) up to 30 feet (9 m) away
using the remote keyless entry transmitter supplied with
your vehicle.

Your remote keyless entry system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, 
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.