Power Flow Display; eAssist Overview ; See Driving and Operating in your Owner Manual.- Page 18

18

eAssist Overview 

(if equipped on fleet/commercial vehicles)

A compact electric assist system called eAssist has been integrated with the highly 

efficient 2.4-liter four-cylinder engine and six-speed automatic transmission to provide 

an electric “boost” to help conserve fuel. eAssist includes a small, but powerful, electric 

motor rated at 15 kilowatts. It replaces the typical alternator found on most engines. 

 eAssist also uses a small, advanced 115-volt lithium-ion battery located in the trunk.

eAssist Features

Auto Start/Stop

While driving, when the brake is applied and the vehicle comes to a complete stop, the 

automatic engine start/stop system may turn off the engine, referred to as an Auto 

Stop. In Auto Stop mode, the tachometer gauge will read AUTO STOP. The audio system, 

climate controls and other accessories will be powered by the high-voltage battery. The 

engine will restart immediately when the brake pedal is released or the accelerator pedal 

is applied.
After parking the vehicle and turning off the engine, the tachometer gauge will read OFF.
There are several conditions that may cause the engine to remain running or restart 

when the vehicle is stopped.
•  The engine, transmission or high-voltage battery is not at the required operating 

 temperature.

•  The outside temperature is less than –4º F (–20º C).
•  The shift lever is in any gear other than Drive (D).
•  The high-voltage battery state of charge is low. It will automatically recharge as the 

vehicle is driven.

•  The climate control system requires the engine to run based on the climate control or 

defog setting. Using the eco Air Conditioning mode will result in more frequent and 

 longer Auto Stops than the Comfort Air Conditioning mode.

•  The Auto Stop time is greater than two minutes.

See Driving and Operating in your Owner Manual.

Power Flow Display

The Power Flow display, located on the infotainment system touch screen, indicates the 

current eAssist operating mode, energy flow direction and high voltage battery charge 

level. The operating modes include Engine Idle, Auto Stop, Engine Power, Hybrid Power, 

and Regen Recovery.

See Instruments and Controls in your Owner Manual.