Fog Lamps; Front Turn Signal Lamps; Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps- Page 258

2020 Buick Regal Owner Manual

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

02-Seats and Restraints_en_US
04-Instruments and Controls_en_US
08-Driving and Operating_en_US
Driving and Operating
09-Vehicle Care_en_US
Vehicle Care
background image

Buick Regal Owner Manual (GMNA-Localizing-U.S./Canada-13557849) -

2020 - CRC - 6/25/19

Vehicle Care

257

3. Disconnect the electrical

connector.

4. Remove the bulb socket from

the headlamp assembly.

5. Reverse Steps 1

4 to install.

High/Low-Beam Headlamps
(Uplevel)

The high/low-beam headlamps on
the uplevel headlamp system are
Light Emitting Diode (LED) and
should be replaced by your dealer.

Fog Lamps

To replace the fog lamp bulb:

1. Locate the bulb assembly

under the front fascia.

2. Disconnect the electrical

connector from the bulb
assembly.

3. Remove the bulb by turning it

counterclockwise and pulling it
straight out of the assembly.

4. Install the new bulb by turning

it clockwise into the assembly.

5. Reconnect the electrical

connector to the bulb
assembly.

Front Turn Signal Lamps

Sidemarkers, daytime running
lamps and turn signal lamps are
LEDs and cannot be changed.

See your dealer.

Taillamps, Turn Signal,
Stoplamps, and Back-Up
Lamps

Driver Side Shown, Passenger

Side Similar

To replace any one of these bulbs:

1. Open the liftgate. See

Liftgate

0

21

.

Detailed Information for 2020 Buick Regal Owner Manual

Lists of information found in 2020 Buick Regal Owner Manual - Page 258

  • 3. Disconnect the electrical connector.
  • 4. Remove the bulb socket from the headlamp assembly.
  • 5. Reverse Steps 1 – 4 to install.
  • 1. Locate the bulb assembly under the front fascia.
  • 2. Disconnect the electrical connector from the bulb assembly.
  • 3. Remove the bulb by turning it counterclockwise and pulling it straight out of the assembly.
  • 4. Install the new bulb by turning it clockwise into the assembly.
  • 5. Reconnect the electrical connector to the bulb assembly.
  • 1. Open the liftgate.