What To Do; BATTERY CHARGE LIGHT; HOUR METER LIGHT- Page 9

Display Panels

15   Display Panels

10

k

BATTERY CHARGE LIGHT

The display shows percent of charge left in the battery.

The display will flash to warn you that the battery is

getting low. Have the battery changed or recharged.

HOUR METER LIGHT

When the key is turned off, the display will show total

seat hours.

EVENT CODE LIGHT

The display shows the code for a detected event.  The

following events can be corrected by the operator.

For other codes contact your supervisor or service

department.

10k LIGHT

Indicates hour meter reading is over 10,000 hours.

METER DISPLAY

During truck operation, the meter will display battery

charge unless a fault is detected.  When the key is turned

off, the meter will display seat hours. The lights below

the display show which mode the meter is in.

STANDARD DISPLAY

Enhanced
Display

Standard
Display

Sit down.  Fasten your seat belt.

Remove foot from accelerator.

Return direction control to neutral.

Make certain battery retainers are secure.

Check brake fluid pressure.

Release parking brake.

What To Do

-08

-05

-02/3/6

-01

-05

Display Panels   16

OPTIONAL ENHANCED DISPLAY

BATTERY CHARGE DISPLAY

The lighted bars show how much charge is left in your

battery. A flashing bar means the battery must be changed

or recharged.

EVENT CODE LIGHT (SERVICE REQUIRED)

The display shows the code for a detected event which

requires service.  Contact your supervisor or service

department.

METER DISPLAY

During truck operation, the display will be blank unless

a fault or other event is detected.  When the key is turned

off, the meter will display seat hours.

EVENT CODE LIGHT (OPERATOR CORRECTABLE)

The display shows the code for a detected event which

the operator can correct.  See chart on page 15, or

event code label on right lift cylinder.