RAISE CUTOUT OVERRIDE SWITCH (optional); WORK LIGHT SWITCH (optional); FLASHING LIGHT SWITCH (optional)- Page 11

Switch Panel  20

Switch Panel

RAISE CUTOUT OVERRIDE SWITCH (optional)

Your truck may be equipped with automatic cutout of

raise at selected lift heights.
To raise past the cutout height, push the optional Raise

Cutout Override switch while, at the same time, pulling

the raise/lower lever toward you (see page 25).

Caution:

Make certain the forks, load and load backrest

will clear all overhead obstructions.

WORK LIGHT SWITCH (optional)

FLASHING LIGHT SWITCH (optional)

Power On & Off

19   Power On & Off

KEY SWITCH

• To start the truck you must be seated, with both feet

on the floorboard (not on any of the pedals), and all

controls in neutral.
• Turn the key clockwise to ON (green dot). Check that

all display lights are working.
• When leaving the truck, turn the key counterclockwise

to OFF (red dot) to shut the truck off.

POWER PEDAL

Push the power pedal with your left foot.  If you are

properly seated and the key is turned ON, the steering

pump will start running and you can operate the truck.
If you remove your foot from the power pedal while

driving, power is cut to all truck operations except for

braking and steering.

POWER DISCONNECT

Push the power disconnect button down to cut power

to the truck.
Use the power disconnect to shut the truck down any

time it isn't working right.  Don't use the truck if it's not

working right. Report the problem to your supervisor.
Pull the power disconnect button up to reconnect the

battery.

USER CODE (PIN number)

A user code (Personal Identification Number) may be

required.  Your company will issue it to you and instruct

you on its use.