Fresh Manuals
Brands
Dodge
Automobiles
Charger

2014 Dodge Charger SRT Owner Manual

Reprogramming A Single HomeLink® Button

Programming A Non-Rolling Code

not release the button.

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
OCCUPANT RESTRAINTS
Child Restraints
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Uconnect® PHONE (4.3)
Uconnect® PHONE (8.4/8.4N)
ADAPTIVE CRUISE CONTROL (ACC) — IF EQUIPPED
UNDERSTANDING YOUR INSTRUMENT PANEL
STARTING AND OPERATING
MAINTAINING YOUR VEHICLE
MAINTENANCE PROCEDURES
Page 292

Detailed Information for 2014 Dodge Charger SRT Owner Manual

Summary of Contents for 2014 Dodge Charger SRT Owner Manual

Page 292: Reprogramming A Single HomeLink® Button
Reprogramming A Single HomeLink® Button To reprogram a channel that has been previously trained, follow these steps: 1. Cycle the ignition to the ON/RUN position. 2. Push and hold the desired HomeLink® button until the
Page 293: Reprogramming A Single HomeLink® Button
• To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. Reprogramming A Single HomeLink® Button To reprogram a channel that has been previously trained, follow these
Page 294: Reprogramming A Single HomeLink® Button
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 3. Continue to push
Page 295: Using HomeLink®
3. Without releasing the button proceed with “Canadian/ Gate Operator Programming” step 2 and follow all remaining steps. Using HomeLink® To operate, push and release the programmed HomeLink® button. Activation will now occur for the programmed device (i.e., garage door opener, gate opera- tor, security
Page 296: General Information
WARNING! Vehicle exhaust contains carbon monoxide, a danger- ous gas. Do not run your vehicle in the garage while programming the transceiver. Exhaust gas can cause serious injury or death. WARNING! Your motorized door or gate

Lists of information found in 2014 Dodge Charger SRT Owner Manual

  • 1. Cycle the ignition to the ON/RUN position.
  • 2. Push and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds.
  • 3. Without releasing the button proceed with “Program- ming A Rolling Code” step 2 and follow all remaining steps.
  • 95. 1.
  • 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view.
  • 3. Simultaneously push and hold both the Homelink® button you want to program and the hand-held trans- mitter button.
  • 4. Continue to hold both buttons and observe the indi- cator light.
  • 5. Push and hold the programmed HomeLink® button and observe the indicator light.
  • If the indicator light stays on constantly, program- ming is complete and the garage door/device should activate when the HomeLink® button is pushed.