2014 Dodge Charger SRT Owner Manual

Disconnecting The Jumper Cables

Do not connect the jumper cable to the negative (-)

post of the discharged battery. The resulting electri-

Model Year
2014 Dodge Charger SRT Owner Manual

Table of Contents

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
OCCUPANT RESTRAINTS
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Uconnect® PHONE (4.3)
Uconnect® PHONE (8.4/8.4N)
UNDERSTANDING YOUR INSTRUMENT PANEL
STARTING AND OPERATING
MAINTAINING YOUR VEHICLE
Page 507

Detailed Information for 2014 Dodge Charger SRT Owner Manual

Summary of Contents for 2014 Dodge Charger SRT Owner Manual

Page 507: Disconnecting The Jumper Cables
WARNING! Do not connect the jumper cable to the negative (-) post of the discharged battery. The resulting electri- cal spark could cause the battery to explode and could result in personal injury. Only
Page 508: FREEING A STUCK VEHICLE
CAUTION! Accessories plugged into the vehicle power outlets draw power from the vehicle’s battery, even when not in use (i.e., cellular phones, etc.). Eventually, if plugged in long enough without engine operation, the vehicle’s battery
Page 509: SHIFT LEVER OVERRIDE
CAUTION! • When “rocking” a stuck vehicle by shifting be- tween DRIVE and REVERSE, do not spin the wheels faster than 15 mph (24 km/h), or drivetrain damage may result. • Revving the engine or spinning the
Page 510: Shift Lever Override
5. Insert a screwdriver or similar tool into the access port (in the left side of the storage bin), and push and hold the override release lever in. 6. Move the shift lever
Page 511: TOWING A DISABLED VEHICLE
TOWING A DISABLED VEHICLE This section describes procedures for towing a disabled vehicle using a commercial wrecker service. Towing Condition Wheels OFF the Ground ALL MODELS Flat Tow NONE IF Transmission is operable: • Transmission in NEUTRAL • 30 mph (48 km/h) max speed • 15 mi

Lists of information found in 2014 Dodge Charger SRT Owner Manual

  • 5. Start the engine in the vehicle that has the booster battery, let the engine idle a few minutes, and then start the engine in the vehicle with the discharged battery.
  • 6. Once the engine is started, remove the jumper cables in the reverse sequence: Disconnecting The Jumper Cables 1.
  • 2. Disconnect the opposite end of the negative (-) jumper cable from the negative (-) post of the booster battery.
  • 3. Disconnect the positive (+) end of the jumper cable from the positive (+) post of the booster battery.
  • 4. Disconnect the opposite end of the positive (+) jumper cable from the remote positive (+) post of the vehicle with the discharged battery.