Blind Spot Alert Off; General Information; Blind Spot Alert Lights/Chime- Page 100

2018 Jeep Wrangler JL User Guide

Table of Contents

background image

Blind Spot Alert Lights/Chime

When operating in Blind Spot Alert Lights/
Chime mode, the BSM system will provide a
visual alert in the appropriate side view mirror
based on a detected object. If the turn signal
is then activated, and it corresponds to an
alert present on that side of the vehicle, an
audible chime will also be sounded. When-
ever a turn signal and detected object are
present on the same side at the same time,
both the visual and audible alerts will be
issued. In addition to the audible alert the
radio (if on) will also be muted.

NOTE:

Whenever an audible alert is requested by the
BSM system, the radio is also muted.

When the system is in RCP, the system shall
respond with both visual and audible alerts
when a detected object is present. Whenever
an audible alert is requested, the radio is also
muted. Turn/hazard signal status is ignored;
the RCP state always requests the chime.

Blind Spot Alert Off

When the BSM system is turned off there will
be no visual or audible alerts from either the
BSM or RCP systems.

NOTE:

The BSM system will store the current oper-
ating mode when the vehicle is shut off. Each
time the vehicle is started the previously
stored mode will be recalled and used.

General Information

The following regulatory statement applies to
all Radio Frequency (RF) devices equipped in
this vehicle:

This device complies with Part 15 of the FCC
Rules and with Industry Canada license-
exempt RSS standard(s). Operation is sub-
ject to the following two conditions:

1. This device may not cause harmful

interference.

2. This device must accept any interference

received, including interference that may
cause undesired operation.

NOTE:

Changes or modifications not expressly ap-
proved by the party responsible for compli-
ance could void the user’s authority to oper-
ate the equipment.

Tire Pressure Monitor System (TPMS)

The Tire Pressure Monitor System (TPMS)
will warn the driver of a low tire pressure
based on the vehicle recommended cold
placard pressure.

NOTE:

The alert warning on the cluster will stay on
until the tire is inflated to the placard pres-
sure.

The tire pressure will vary with temperature
by approximately 1 psi (7 kPa) for every 12°F
(6.5°C). This means that when the outside
temperature decreases, the tire pressure will
decrease. Tire pressure should always be set
based on cold inflation tire pressure. This is
defined as the tire pressure after the vehicle
has not been driven for at least three hours, or
driven less than 1 mile (1.6 km) after a three
hour period. The cold tire inflation pressure
must not exceed the maximum inflation pres-

SAFETY

98

Detailed Information for 2018 Jeep Wrangler JL User Guide

Lists of information found in 2018 Jeep Wrangler JL User Guide - Page 100

  • 1. This device may not cause harmful interference.
  • 2. This device must accept any interference received, including interference that may cause undesired operation.
  • 6.5°C).
  • 1.6 km) after a three hour period.

Related Documents for 2018 Jeep Wrangler JL User Guide