Sway Bar Switch- Page 167

2018 Jeep Wrangler JL User Guide

Table of Contents

background image

• Both right and left wheels on axle are at the

same speed.

To activate the system, push the AXLE LOCK
switch down to lock the rear axle only (the
“REAR ONLY” will illuminate), push the
switch up to lock the front axle and rear axle
(the “FRONT + REAR” will illuminate). When
the rear axle is locked, pushing the bottom of
switch again will lock or unlock the front axle.

NOTE:

The indicator lights will flash until the axles
are fully locked or unlocked.

To unlock the axles, push the AXLE LOCK
OFF button.

Axle lock will disengage if the vehicle is taken
out of 4L (Low) range, or the ignition switch is
turned to the OFF position.

The axle lock disengages at speeds above
30 mph (48 km/h), and will automatically
re-lock once vehicle speed is less than
10 mph (16 km/h).

Electronic Sway Bar Disconnect —
If Equipped

Your vehicle may be equipped with an elec-
tronic disconnecting stabilizer/sway bar. This
system allows greater front suspension travel
in off-road situations.

This system is controlled by the SWAY BAR
switch located on the instrument panel (to
the right of the steering column).

Push the SWAY BAR switch to activate the
system. Push the switch again to deactivate
the system. The “Sway Bar Indicator Light”
(located in the instrument cluster) will illumi-
nate when the bar is disconnected. The
“Sway Bar Indicator Light” will flash during
activation transition, or when activation con-
ditions are not met. The stabilizer/sway bar
should remain in on-road mode during nor-
mal driving conditions.

WARNING!

Ensure the stabilizer/sway bar is recon-
nected before driving on hard surfaced
roads

or

at

speeds

above

18

mph

(29 km/h); a disconnected stabilizer/sway
bar may contribute to the loss of vehicle
control, which could result in serious in-
jury. Under certain circumstances, the
front stabilizer/sway bar enhances vehicle
stability and assists with vehicle control.
The system monitors vehicle speed and
will attempt to reconnect the stabilizer/
sway

bar

at

speeds

over

18

mph

(29 km/h). This is indicated by a flashing
or solid “Sway Bar Indicator Light.” Once

Sway Bar Switch

165

Detailed Information for 2018 Jeep Wrangler JL User Guide

Lists of information found in 2018 Jeep Wrangler JL User Guide - Page 167

  • Both right and left wheels on axle are at the same speed.

Related Documents for 2018 Jeep Wrangler JL User Guide