Always check the Owner’s Manual for more operating information and safety features ; front air bag ; Tip: Turn ignition off when - Page 5

S E A T S

Always check the Owner’s Manual for more operating information and safety features 

Seats

Seats/

Console

Quick Tips

Mazda

Mazda B-Series Truck

page 8
page 9

Passenger’s
front air bag 
deactivation
switch

Deactivate 
passenger’s 
front air bag

when using a child-safety seat
To deactivate/activate: Insert 
ignition key in switch, rotate 
to OFF/ON, remove key
Amber OFF light illuminates when
deactivated and ignition is on

Tip: Turn ignition off when 
disabling passenger front air bag

WARNINGS: When using a 
rear-facing infant-safety seat
or a front-facing child seat,
always set the passenger seat
air bag deactivation switch to
OFF position, an infant or child
is in serious danger of being
injured or killed if front passenger
air bag is deployed 

Console (Split bench)
1. Coin tray
2. Map storage
3. Storage compartment

If you install a front-
facing child-seat, put it in 
the outboard seat and slide 
it all the way rearward, set
passenger air bag deactivation
switch to OFF position
For Cab-Plus vehicles, do not 
put child restraints in the center
facing jump seats, for complete
details see Owner’s Manual

Child-safety seat

To install, use dual-locking mode
retractor safety belts; see Owner’s
Manual for proper installation 
and child seat tether and 
LATCH system instructions 

WARNING:  Use age 
appropriate child restraints, 
see Owner’s Manual and 
state or province laws

1

2

Dual locking mode
lap/shoulder belt retractor
(passenger seat only)

Emergency locking mode: Belt
locks only on hard braking/
cornering or impacts of about 
5 mph or higher 
Automatic locking mode: Must 
be used when installing child- 
safety seat
To activate: Pull webbing fully 
out of retractor; belt will only
tighten
To disengage: Unbuckle belt 
and allow webbing to retract 
fully, for complete details see
Owner’s Manual

3

2

1

Seats

1. Fore/aft adjustment

Raise lever and hold, slide 
seat, release lever

2. Seatback angle

To adjust: Lift and hold lever,
lean forward or backward 
to tilt seat, release lever

WARNINGS: Do not adjust 
seats while driving
Safety belts must always 
be worn when vehicle 
is in motion
All air bags are supplemental
and do not replace safety 
belt usage
Always wear your 
safety belt and properly 
secure children

Shoulder belt
height 
adjustment

To raise belt: 
Slide adjuster up
To lower belt: 
Push release 
button (

3

) and 

slide down

WARNING: 
Make sure 
adjuster locks 
in one of its 
positions

*Denotes optional equipment

ON

OFF

OFF

PASSENGER AIR BAG

3