Always check the Owner’s Manual for more operating information and safety features ; WARNINGS: Use age ; appropriate child restraints,- Page 6

S E A T S

Always check the Owner’s Manual for more operating information and safety features 

Seats

Seats

WARNINGS: Use age 
appropriate child restraints,
see Owner’s Manual and 
state or province laws
When using a rear-facing
infant-safety seat or a front-
facing child seat, always set
the passenger seat air bag
deactivation switch to OFF
position, an infant or 
child is in serious danger of
being injured or killed if front
passenger air bag is deployed 

If you must install a 
front-facing child-seat, 
put it in the outboard seat 
and slide it all the way rear-
ward, set passenger air bag
deactivation switch to 
OFF position
For Cab Plus vehicles, do not 
put child restraints in the center
facing jump seats, for complete
details see Owner’s Manual

Child-safety seat

To install, use dual-locking mode
retractor safety belts; see Owner’s
Manual for proper installation 
and child seat tether and 
LATCH system instructions 

1

2

Seats

1. Fore/aft adjustment

Raise lever and hold, slide 
seat, release lever

2. Seatback angle

To adjust: Lift and hold lever,
lean forward or backward 
to tilt seat, release lever

WARNINGS: Do not adjust 
seats while driving
Safety belts must always be
worn when vehicle is in motion
All air bags are supplemental
and do not replace safety 
belt usage
Always wear your safety 
belt and properly secure 
children in age appropriate
child restraints and deactivate 
passenger seat air bag

Shoulder belt 
height 
adjustment

To raise belt: 
Slide adjuster up
To lower belt: 
Push release 
button (

3

) and 

slide down

WARNING: 
Make sure 
adjuster locks 
in one of its 
positions

Safety belt emergency
locking mode

Belts lock only on hard 
acceleration, braking, cornering 
or impacts of about 5 mph 
or more

Automatic locking mode 
(front passenger safety 
belt only)

Must be used when installing
child-safety seat
To activate: Pull webbing fully 
out of retractor, allow belt to
retract until click is heard; belt 
will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fully

3