replace Step 3 of Programming; the HomeLink System; Operating the HomeLink System- Page 206

▼

Gate operator/Canadian
Programming

Canadian radio-frequency laws require
transmitter signals to “time-out” (or
quit) after several seconds of
transmission 

―

 which may not be long

enough for HomeLink to pick up the
signal during programming. Similar to
this Canadian law, some U.S. gate
operators are designed to “time-out”
in the same manner.
 
If you live in Canada or are having
difficulties programming a gate
operator by using the programming
procedures (regardless of where you
live), 

replace Step 3 of Programming

the HomeLink System

 with the

following:

NOTE

If programming a garage door opener
or gate operator, it is advised to unplug
the device during the “cycling” process
to prevent possible overheating.

While the indicator light is flashing in
amber, press the button on the
hand-held transmitter for 2 seconds
and release it repeatedly until the
indicator light changes from amber to
green.
Go back to Step 4 of Programming the
HomeLink System to complete the
procedure.

▼

Operating the HomeLink System

Press the programmed HomeLink
button to operate a programmed
device.

▼

Reprogramming the HomeLink
system

To program a device to HomeLink
using a HomeLink button previously
trained, follow these steps:
1. Press and hold the desired

HomeLink button. 

DO NOT

 release

the button.

2. After 20 seconds, the indicator light

flashes in amber. After the indicator
light flashes, release the HomeLink
button.

3. Go back to Step 2 of Programming

the HomeLink System to complete
the procedure.

NOTE

If the programming has not been
completed, the system returns to the
previous programming.

When Driving

Switches and Controls

4-60

CX-30_8JP5-EA-20K_Edition1_new

2020-7-22 15:50:09