When Driving; hold for two seconds and release; press and release ―- Page 241

8. Firmly press and release the “learn” or

“smart” button. (The name and color
of the button may vary by
manufacturer.)

NOTE

Complete the programming within 30
seconds.

9. Return to the vehicle and firmly 

press,

hold for two seconds and release

 the

programmed HomeLink button. Repeat
the “

press/hold/release

” sequence a

second time, and, depending on the
brand of the garage door opener (or
other rolling code equipped device),
repeat this sequence a third time to
complete the programming process.

HomeLink should now activate your
rolling code equipped device.

NOTE

To program the remaining two HomeLink
buttons, begin with “Programming”

―

step 1

For questions or comments, please contact
HomeLink at 

www.homelink.com

 or

1-800-355-3515

.

▼

Gate operator/Canadian
Programming

Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission ―
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are designed
to “time-out” in the same manner.
 

If you live in Canada or you are having
difficulties programming a gate operator
by using the “Programming” procedures
(regardless of where you live), 

replace

“Programming HomeLink” step 3

 with

the following:

NOTE

If programming a garage door opener or
gate operator, it is advised to unplug the
device during the “cycling” process to
prevent possible overheating.

Continue to press and hold the HomeLink
button while you 

press and release ―

every two seconds

 (“cycle”) your

hand-held transmitter until the frequency
signal has successfully been accepted by
HomeLink. (The indicator light will flash
slowly and then rapidly.)
Proceed with “Programming” step 4 to
complete.

▼

Operating the HomeLink System

Press the programmed HomeLink button
to operate a programmed device. The code
will continue being transmitted for a
maximum of 20 seconds.

▼

Reprogramming the HomeLink
system

To program a device to HomeLink using a
HomeLink button previously trained,
follow these steps:
1. Press and hold the desired HomeLink

button. 

DO NOT

 release the button.

2. The indicator light will begin to flash

after 20 seconds. Without releasing the
HomeLink button, proceed with
“Programming” - step 1.

When Driving

Switches and Controls

4-87

CX-5_8HE3-EA-18I_Edition1

2018-6-29 13:44:47